![]() Meaning, anything applied on it will be absorbed instantly, resulting in stains or faint marks on the surface. In the past, chalkboards were made of sheets of slate, which is a porous material. Liquid chalk markers are designed to be used mainly on non-porous surfaces such as glass, metals, plastics, ceramics, and other materials that don’t permit the passage of air or water. ![]() I used my Ryobi Eye Hook Bolt Driver bit to screw an eye hook at the top ends of the chalkboard frame.You would think that the answer would be an unqualified yes, but the name “liquid chalk markers” refers to the effect of these markers, not their composition. (Finish nails and a hammer will also work here). I flipped over the frame and used my Airstrike Crown Stapler, with 3/4″ staples, to attach the chalkboard to the back of the frame. ![]() Once the paint is dry, use an 80-grit piece of sand paper and just rub it back and forth on the piece. Only one coat! As the paint dries it will be a light coat that you can see through – this is a good thing. Once the stain was dry, I used a paint brush to apply one coat of Rust-Oleum Chalked paint to the entire piece. I let it sit for about 5 minutes and then I wiped it with a clean cloth blend the stain. I applied one coat of Varathane Dark Walnut stain, with a clean cloth, to the frame. It’s easier to finish the frame without it.* Time for the finish! *Don’t attach your chalkboard yet. This is what your frame will look like now. Now, measure the short ends from one side to the other and cut another 1×2 piece to fit each end. You want the 1×2 to cover the sides of the chalkboard so you do not see them when it is hanging. It is important to lay the frame over the chalkboard before attaching the 1×2 pieces. ![]() If you don’t have a nailer, you can use hammer and nails here. I attached the 1×2 with my Ryobi 18V Airstrike Brad nailer and 1 1/4″ brad nails. Next, I measured the length of the long sides from end to end and cut a 1×2 piece to fit. Then, I laid the frame over the chalkboard making sure the edges of the frame were flush with the edges of the chalkboard. Next, I attached the 43″ boards to the 24″ boards with 1 1/4″ pocket hole screws. You can click HERE to purchase a Kreg Jig from Amazon). (You can watch our “How to Use a Kreg Jig” video HERE. I used my Kreg K5 to drill 3/4″ pocket holes in to both ends of the 43″ boards. I cut 2 1×3 pieces at 24″ and 2 1×3 pieces at 43″. My measurements are just a go-by for you. Make sure to measure the chalkboard before making cuts. I started with a 2×4 sheet of chalkboard (found at Home Depot) Stapler (hammer and finish nails will work too) Nailer (hammer and finish nails will work too) Here’s a list of the materials you need to create this DIY Hanging Chalkboard:ġ – 1×3 – 1×3 – 1×2 – 2’x4′ sheet of chalkboard (Home Depot) If you had the chance to see our pilot, Open Concept, on HGTV, you might have caught a peek at this guy □ Not only is it easy to build, the distressed finish is quick and easy too (and currently my fave finish)! This DIY Hanging Chalkboard is the PERFECT project for a beginner! The steps are simple, it only requires a few tools AND it’s just so darn cute!
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |